Out-of-Plane Design of Reinforced Masonry Bearing Walls
by Richard Bennett, Ph.D., P.E.
July 11, 2019; 11:00 AM - 1:30 PM Pacific TimeSmall Business System Requirements FAQ Register
ICC Preferred Provider Course Number: 14535
The out-of-plane design of reinforced masonry bearing walls for wind, seismic and soil loads using both the allowable stress and strength design procedures will be covered. Differences between the methods will be highlighted. The effect of recent code changes on the design of the walls will also be covered. Time- and cost-saving tips will be provided for designing walls, including avoiding iteration with strength design of walls loaded out-of-plane and consideration of deflection. The new moment magnifier procedure that was added to the 2013 TMS 402 Code will be shown. Examples illustrating the principles as well as common mistakes will be presented.
Richard Bennett, Ph.D, P.E. is a Professor of Civil and Environmental Engineering at the University of Tennessee. He is a Fellow of The Masonry Society. He is a member of ASTM C12 on Mortars and Grouts for Unit Masonry, and ASTM C15 on Manufactured Masonry Units. Dr. Bennett has been very active in the Masonry Standards Joint Committee which writes the Building Code for Masonry Structures. He has chaired the Flexural, Axial Loads, and Shear subcommittee and served as the vice-chair of the 2013 MSJC Committee. Dr. Bennett was the chair of the main committee for the 2016 402/602 code. He is 2nd vice chair for the next code cycle, which will develop the 2022 provisions.
|1 Connection||2 Connections||3 Connections||4 Connections||5 Connections||> 5 Connections|
|* Registration on or before July 9, 2019|
Please note a single registration allows you to have one connection. However, a number of people can view and listen to the seminar using one connection by using an LCD projector (or a large computer monitor) and good computer speakers or a speaker phone.
All attendees, irrespective of the number of registered connections, can earn 0.25 Continuing Education Units (CEUs) or 2.5 professional development hours (PDHs). CEU/PDH certificates are provided free of charge.
- A connection is defined as a single web connection plus a single telephone connection (if necessary). If you want to sign up for more than one connection for this seminar, you will have the opportunity to do so after placing the seminar in your cart.
- A $15 fee will apply if the seminar registrant wishes to revise the web seminar registration (e.g. switch from one web seminar to another).
- Refunds are limited to 80 percent of fee and must be applied for in writing WITHIN THIRTY DAYS after the scheduled seminar.
- We are a registered provider for continuing education in the State of Florida (Provider # 4732), the State of New York (Provider # 99), the State of New Jersey (Provider # 24GP00014200), the State of Maryland, and for the Structural Engineers Certification Board (SECB) of the National Council of Structural Engineers Associations (NCSEA).