|
Code Simples
 Dowty, S.
and Ghosh, S.K., "Seismic ground motion values for locations outside the United States", Structural Engineer,
February 2010.
Dowty, S.
and Ghosh, S.K., "2009 IBC Section 1604.8.2: Walls", Structural Engineer,
December 2009.
Dowty, S.
and Ghosh, S.K., "ASCE 7-05 Sections 12.2.2 and 12.2.3: Combinations of seismic
force-resisting systems", Structural Engineer, October 2009.
Ghosh,
S.K. and Dowty, S., "2006 IBC Chapter 2: Defined Terms", Structural Engineer, August 2009.
Ghosh,
S.K. and Dowty, S., "2009 IBC Section 1609.6:
Alternate All-Heights Method", Structural Engineer, June 2009.
Ghosh,
S.K. and Dowty, S., "ASCE
7-05: Seismic design of free-standing walls", Structural Engineer, April 2009.
Ghosh,
S.K. and Dowty, S., "ASCE 7-05 Section 12.2.5.5: Special Moment Frames in Structures
Assigned to Seismic Deisgn Categories D through F", Structural
Engineer, Feb 2009.
Ghosh,
S.K. and Dowty, S., "ASCE 7-05 Section 12.6: Analysis Procedure Selection ", Structural
Engineer, Dec 2008.
Ghosh,
S.K. and Dowty, S., "Section 12.12.3 Building Separation and
Section 12.8.7 P-Delta Effects", Structural
Engineer, Oct 2008.
Ghosh,
S.K. and Dowty, S., "
Ghosh,
S.K. and Dowty, S., "ASCE 7-05 Supplement No.2", Structural
Engineer, June 2008.
Ghosh,
S.K. and Dowty, S., "2006 IBC Section 1605.2.1: Seismic Strength Design Load Combinations", Structural
Engineer, April 2008.
Ghosh,
S.K. and Dowty, S., "2006 IBC Section 1605.4: Special Seismic Load Combinations", Structural
Engineer, February 2008.
Ghosh,
S.K. and Dowty, S., "1997 UBC vs. 2006 IBC Concrete Anchor
Design", Structural Engineer, December 2007.
Ghosh,
S.K. and Dowty, S., "Section 1802: Foundation and soils investigations", Structural Engineer, October 2007.
Ghosh,
S.K. and Dowty, S., "Section 1609.4.3 Exposure D", Structural Engineer, August 2007.
Ghosh,
S.K. and Dowty, S., "Section 1605.3 Load Combinations Using
Allowable Stress Design", Structural Engineer, June 2007.
Ghosh,
S.K. and Dowty, S., "ASCE 7-05 Seismic Provisions Errata",
Structural Engineer, April 2007.
Ghosh,
S.K. and Dowty, S., "CODE SIMPLE: ASCE 7-05 Table 12.2-1
Bearing Wall System vs. Building Frame System", Structural
Engineer, February 2007.
Ghosh,
S.K., "Searching for simplicity: The evolution of wind provisions
in standards and codes in the United States - Part 2", Structural
Engineer, January 2007.
Ghosh,
S.K., "Searching for simplicity: The evolution of wind provisions
in standards and codes in the United States - Part 1", Structural
Engineer, Vol. 7, No.11, December 2006.
Ghosh,
S.K. and Dowty, S., "ASCE 7-05 Figure 11.4-1 Design Response
Spectrum," Structural Engineer, Vol. 7, No.11, December 2006.
Ghosh,
S.K. and Dowty, S., "Section 1801.2.1 Foundation design for
seismic overturning ," Structural Engineer, Vol. 7, No.9,
October 2006.
Ghosh,
S.K. and Dowty, S., "Section 1602.1 Definitions (Diaphragm,
flexible) and Section 1617.5.3 Horizontal Distribution ,"
Structural Engineer, Vol. 7, No.7, August 2006.
Ghosh,
S.K. and Dowty, S., "Section 1620.4.5: Building Separations
," Structural Engineer, Vol. 7, No.5, June 2006.
Ghosh,
S.K. and Dowty, S., "Section 1617.6: Seismic-Force-Resisting
Systems ," Structural Engineer, Vol. 7, No.3, April 2006.
Ghosh,
S.K. and Dowty, S., "Section 1607.9 Passenger Vehicle Parking
Garage Live Loads ," Structural Engineer, Vol. 7, No.1, February
2006.
Ghosh,
S.K. and Dowty, S., "1617.2 - Redundancy ," Structural
Engineer, Vol. 6, No.11, December 2005.
Ghosh,
S.K. and Dowty, S., "1617.4 — Equivalent Lateral Force
Procedure for Seismic Design of Buildings," Structural Engineer, Vol.
6, No.9, October 2005.
Ghosh,
S.K. and Dowty, S., "Section 1614.1 Earthquake Loads — Exception
1" Structural Engineer, Vol. 6, No.7, August 2005.
Ghosh,
S.K. and Dowty, S., "1615.1.3 Design spectral response acceleartion
parameters," Structural Engineer, Vol. 6, No.5, June 2005.
Ghosh,
S.K., Dowty, S. and Bachman, R, "Changes to the seismic provisions,"
Structural Engineer, Vol. 6, No.1, February 2005.
|
